Manual

Assembly and Installation | 23
IR Repeater Installation
INSTALLATION ASSEMBLY COMPONENTS
• Infrared sensor
• Mounting collar
• IR-100 control unit
• IR flasher LED
• 9–12VDC power supply
• Connection cable
• Flathead mounting screws
REQUIRED TOOLS FOR INSTALLATION
• Electric drill
• 1-in hole saw to create a
• 1/16-in drill bit
• Small flat blade screwdriver
• Phillips #2 bit driver
• Adhesive tape
INSTALLATION STEPS
1. Choose a location for the IR infrared sensor that is away from traffic.
2. Using a 1-in hole saw, cut an opening in the floor for the IR sensor.
3. Connect the V+, GND, and SIG wires to the IR sensor as shown in the
diagram, and feed the cable through the hole.