Manual

Model 2090 Multi-Device Controller

*TST? Self Test 1090, 2090

*WAI Wait To Continue 1090, 2090

These commands are not supported by the Model 2190 Virtual Device Controller

since it does not have auxiliary control ports.

These commands are obsolete as defined. On the models 1050 and 1060, these

commands changed the front panel to display the specified value and prepared the

controller to respond to all future reads with that value. This is not compatible

with the IEEE 488.2 standard; the program must send the command before each

read. For programs which will not be used with a model 1050 or 1060, use the

corresponding query commands (command followed by a question mark (?)).

This command is obsolete. For programs which will not be used with a model

1050 or 1060, use the corresponding set commands (leave the LD command off of

the corresponding limit or position value).

Detailed Description of MODEL 2090 GPIB Commands

The following notation will be used for each command:

COMMAND NAME

Compatibility:

Backwards compatibility and revision history information

Description:

Description of the command function and any associated special information.

Devices:

List of devices types this command applies to. “Towers” refers to all linear

positioning devices; “Turntables” refers to all rotational positioning devices

Syntax:

CMD <required parameter> [optional parameter]

parameter list List of parameters and their descriptions (as

required) with any associated special information.

Response:

response If applicable, description of expected response from

queries, with any associated special information.

Example:

CALL ibwrt (TowerUD%, "CMD parm") ' Sample Visual Basic GPIB

' calls and associated comments