User Manual

Operation MODEL 2065 LOPRO TURNTABLE
26 © EMC TEST SYSTEMS, L.P. – APRIL 2002
REV F – PN 399230
CABLE PATH
There is a 1 cm (.40 in) high by 2.54 cm (1.0 in) wide slot on the
bottom side of the TT base that can be used to run 3/8 inch
maximum DIA cable from the side up through the center opening
of the TT.
BELT TENSION
The drive belt is furnished fully tensioned on new units. After
usage the belt may need to be tightened. (Refer to drawing 5 at the
back of this manual.) To take up any slack in the belt, loosen the 6
bolts on the gearbox, move it outward and retighten.
Archived 3/18/10