User`s manual

Perform the steps in “Clean the ActiveX and IE Cache & History” below, using

Etroscan change the network settings (if applicable), then check the System

Information page to verify the upgrade has been completed successfully.

Upgrade using SD Card

The SD card should be empty of any existing files before proceeding.

1. Rename the firmware file to ev-fw.bin, and copy the file to the SD card.

2. Insert the card into the camera’s SD card slot.

3. Power on the camera, and wait about 1 minute.

The green power LED will flash quickly during the upgrade, become stable

briefly and slowly blink while performing a reboot.

4. Check EtroScan to verify the camera is available (IP address may have

changed to factory default, 192.168.1.2).

5. Remove the SD card.

6. After web UI access is once again available, review the System Information

page to verify the upgrade has completed successfully.

Clean the ActiveX and IE Cache & History

After upgrading, the ActiveX controls and IE cache & history should be cleared

to prevent old pages and controls from being used.

Close all instances of IE and open 1 IE window. In the right corner, select Tools-

>Manage Add-ons

In the Manage Add-ons window, select “All add-ons”