User manual

04
45
NO SOFTWARE INSTALLATION REQUIRED
There is no installation or setup of any software for Windows XP/2000
platforms.
STEPS FOR USING ETROLINK™ config port (Windows XP PC)
1. Disconnect power cable connected to EV3151 / EV3151A.
2. Use mini-USB cable and connect appropriate end to Etrolink™ config
port and connect other end to PC USB port.
3. After 5 ~ 10 seconds depending on how fast your PC is, you can
notice “Disk drive
” being detected.
4. A POP-UP dialog shows “Config Wizard
” is ready to run. Press OK.
091107