Service manual

Page 91 of 151

• Remove the starter reduction gear and shaft.

• Pull out the flywheel with a flywheel puller tool.

Special tool:

Flywheel puller tool

• Remove the flywheel and starting driven gear.

10-7 Starting Clutch

Starting Clutch Inspection

• Remove the starting clutch driven gear.

• Inspect the gear for wear or damage.

• Measure the ID and OD of the starting clutch

driven gear.

Service Limit: ID: 25.1 mm

OD: 42.10 mm

• Inspect the starting reduction gear and shaft for

wear or damage.

• Check each roller for wear or damage.