Service manual

Page 89 of 151
10-3 Right Crankcase Cover
Removal
• Remove the left footrest.
• Drain out the engine oil and coolant.
• Remove the coolant hoses.
• Remove the water pump cover (4 bolts).
• Remove 11 bolts from the right crankcase cover.
• Remove the right crankcase cover.
• Remove dowel pin and gasket.
10-4 A/C Generator Removal
• Remove the 2 mounted screws from the A/C
Generator.
• Remove the A/C Generator.
• Remove 3 screws from right crankcase cover.
• Remove the generator coil set.
10-5 Right Cover Bearing
Inspection
• Rotate the bearing with your finger. Make sure
the bearing turns smoothly and quietly.
• Check if the bearing outer parts are closed and
fixed. Replace if necessary.
• Remove the cir clip.
• Remove the bearing.
Special tool:
Inner bearing puller
Copyright ©2008-2009 ETON America, llc., all rights reserved.
www.Get2itParts.com
www.Get2itParts.com
www.Get2itParts.com