Service manual

Page 82 of 151
9-6 Bearing Replacement
• Never install used bearings. Once a bearing
is removed, it must be replaced with new one.
Crankcase side
• Remove the drive shaft bearing setting plate.
• Remove the drive shaft bearing from left
crankcase.
• Remove the reverse shaft bearing and counter
shaft bearing from the left crankcase.
• Remove the drive shaft oil seal.
Special tool:
Inner bearing puller
• Install new final shaft, counter shaft, and
reverse shaft bearings into the left crankcase.
Special tool:
Bearing driver (6204)
Needle bearing driver (HK2016)
• Install new drive shaft bearings with a
bearing driver into the left crankcase.
• Install the universal bearing puller with the
bearing driver.
• Turn the universal bearing puller to install the
drive shaft bearing.
Special tool:
Bearing driver (6305)
Universal bearing puller
Copyright ©2008-2009 ETON America, llc., all rights reserved.
www.Get2itParts.com
www.Get2itParts.com
www.Get2itParts.com