Service manual

Page 74 of 151
• Install the collar.
• Install the friction plate, spring, and clutch
weight onto a clutch spring compressor,
and press down the assembly by turning
the manual lever until the mounting nut
can be installed.
• Hold the compressor with a bench vise and
tighten the mounting nut to specified
torque with clutch nut wrench.
• Remove the clutch spring compressor.
• Torque value: 5.0-6.0kgf-m / 36-43 lbf-ft
• Install clutch outer/driven pulley and drive
belt onto drive shaft
.
Copyright ©2008-2009 ETON America, llc., all rights reserved.
www.Get2itParts.com
www.Get2itParts.com
www.Get2itParts.com