Service manual

Page 58 of 151

• Measure the outer diameter of the piston pin.

Service Limit: 17.00 mm

• Measure the inner diameter of the smaller end

of the connecting rod.

Service Limit: 17.02 mm

• Measure the inner diameter of the piston pin hole.

• Service Limit: 17.02 mm

• Calculate the clearance between the piston pin and

its hole.

• Service Limit: 0.02 mm

• Measure the piston outer diameter.

• The measurement position is 10 mm from the

piston bottom side, at a 90° angle to the piston pin.

• Service limit: 71.00 mm

• Compare measured value with service limit to

calculate the clearance between piston and

cylinder.