Service manual

Page 51 of 151

6-9 Cylinder Head Installation

• Clean off any residue and foreign materials on the

surfaces of the cylinder and cylinder head.

• Install the chain guide, dowel pins and a new cylinder

head gasket onto the cylinder.

• Do not damage the surfaces of the cylinder

and cylinder head.

• Do not allow any gasket material to fall into

the crankcase.

• Install the 4 washers and tighten the 4 nuts on the

top of the cylinder head, and then tighten the 2

cylinder head mounting bolts on the right side of

the cylinder

Torque values:

Nut: 26-29 lbf-ft

Bolt: 7-10 lbf-ft

• Install the camshaft into the cylinder head.

• Install the rocker arm and rocker arm shaft.

• Install the rocker arm pin mounting plate.