Service manual

Page 42 of 151
• Remove the LH clutch cover and turn the
drive face counterclockwise, aligning the timing
mark on the sprocket with that of cylinder head
so the piston is at the TDC position.
• Remove cam sprocket bolts.
• Remove the sprocket by prying the chain out.
• Remove the cam shaft setting plate (1 bolt).
• Remove rocker arm shafts and rocker arms.
• Special Service Tool Needed: Rocker
arm and cam shaft puller
• Remove the cam shafts.
• Special Service Tool Needed: Rocker
arm and cam shaft puller
Timing Marks
Setting Plate
Rocker Arm
Shafts
Cam Shafts
Copyright ©2008-2009 ETON America, llc., all rights reserved.
www.Get2itParts.com
www.Get2itParts.com
www.Get2itParts.com