Service manual

Page 23 of 151

4-4 Engine Oil

• Turn off engine, and park the ATV on a flat surface.

• Check the oil level with oil dipstick. Do not screw in

the dipstick when checking the level.

• If the level is low, fill with the recommended oil to the

upper level.

• Drain oil when the engine is warm so it drains completely.

• Place an oil pan under the ATV.

• Remove the oil drain bolt.

• Drain the oil.

• Remove the oil strainer and spring.

• Clean the oil strainer.

• Check the O-ring, and replace if necessary.

• Install oil drain bolt, spring, and strainer.

• Torque value: 19 N-m / 14 lbf-ft – 25 N-m / 18 lbf-ft

• Add recommended oil (SAE 10W30) – 1.2L / 1.2 qt.

• Start the engine and allow to run for several minutes.

• Stop the engine and check the engine oil level again,

Verify there are no engine oil leaks.

4-5 Transmission Oil Change

• Drain oil when the engine is warm so it drains completely.

• Place an oil pan under the ATV.

• Remove the oil drain bolt.

• Drain the oil.

• Verify the washer can be reused. Replace if not.

• Install the drain bolt.

• Torque the drain bolt: 10 N-m / 7 lbf-ft – 15 N-m / 10.7 lbf-ft

• Add recommended gear oil

(85/140 W Gear oil) – 650cc / 22oz

Dipstick

O-Ring

Strainer

Drain Bolt

Transmission Gear

Oil Drain Bol