Service manual

Page 19 of 151

3. ENGINE REMOVE AND INSTALLATION

3.1 General Information

ENGINE SHOULD BE REMOVED ONLY WHEN NECESSARY TO REPAIR

OR ADJUST THE TRANSMISSION OR COMBUSTION SYSTEMS.

3.2 ENGINE REMOVAL

Before removing engine, remove all of components such as seat, front and rear body cover,

fuel tube, exhaust pipe, carburetor cable and drive chain. The engine is attached with three

hanger bolts which will be visible after removing the components.

Loosen these three hanger bolts. Two of these are in the rear of the engine, and one is in the

front. The engine can now be removed.

Disconnect the wire connectors. There are three connectors: carburetor auto-choke,

starter motor, and generator.

• Remove the drive chain cover.

• Remove the drive chain retaining clip and

master link.

• Remove the drive chain.

• Front hanger bolt.