Service manual

Page 18 of 151
2.13 TOE-IN
• Place the vehicle on level ground and
align the front wheels so they are
facing straight ahead.
• Mark the centers of the tires to indicate
the axle center height.
• Measure the distance between the
marks.
• Carefully move the vehicle backward,
letting the wheels turn 180 degrees, so
the marks on the tires are aligned with
the axle center height.
• Measure the distance between the
marks.
• Calculate the difference between the
front and rear measurements.
• Toe-in: 5±10mm
• If the toe-in is out of the specification,
adjust it by changing the length of the
tie-rods equally by turning the tie-rod
while holding the ball joint.
• Tighten the lock nuts.
• Torque: 35-43 N-m
Locking Nut
Copyright ©2008-2009 ETON America, llc., all rights reserved.
www.Get2itParts.com
www.Get2itParts.com
www.Get2itParts.com