Service manual

Page 132 of 151

REPLACING THE BRAKE HYDRAULIC OIL

• Loosen the bolts and open the cover of the

reservoir.

• Loosen the drain bolt and drain the used oil out.

• Tighten the bolt after the used oil has been

drained out completely.

• Add the brake oil (DOT 3 or DOT 4).

• Keep oil level at least halfway up the cup to

prevent air from getting into the brake system.

• Loosen the bolt to vent the air from brake system.

• Tighten the bolt if there isn’t any air in the brake

system.

• Tightening torque: 40-70kgf-cm / 35-61 lbf-in

• Pull the left brake lever gently to extract air from

brake system.

• Fill the brake oil to the level shown on the cup

when no more air comes out.

• Assemble the cover