Service manual

Page 117 of 151
13.2 TROUBLESHOOTING
• Steering Too Hard
o Faulty tire
o Steering shaft holder too tight
o Insufficient tire pressure
o Faulty or damaged steering shaft bushing
• Front Wheel Wobbles
o Faulty tire
o Worn front brake drum bearing
o Bent rim
o Axle nut not tightened properly
• Steering Pulls To One Side
o Bent tie rods
o Wheel installed incorrectly
o Unequal tire pressure
o Bent frame
o Worn swing arm pivot bushings
o Incorrect wheel alignment
• Nose in the Front Suspension
o Loose front suspension fasteners
o Suspension link bound
• Hard Suspension
o Faulty front swing arm bushings
o Improperly installed front swing arms
o Bent front shock absorber swing rod
• Soft Suspension
o Weak front shock absorber springs
o Worn or damaged front swing arm bushings
13.3 HANDLEBAR
REMOVAL
• Remove the throttle housing by the two fixed
screws.
• Remove the throttle lever housing on the right
side of the handle bar.
• Remove the brake lever bracket assembly.
Copyright ©2008-2009 ETON America, llc., all rights reserved.
www.Get2itParts.com
www.Get2itParts.com
www.Get2itParts.com