User guide

9
Etisalat HSPA WiFi Router USER GUIDE
2.1 Default Settings
The following are the default settings for the Router
Local (LAN) access (username: admin, password: admin)
Remote (WAN) access (username: support, password: support)
User access (username: user, password: user)
LAN IP address: 192.168.1.1
Remote WAN access: disabled
NAT and firewall: enabled
Dynamic Host Configuration Protocol (DHCP) server on LAN interface: enabled
Technical Note:
During power on, the device initializes all settings to default values. It will then read the configuration profile from the
permanent storage section of flash memory. The default attributes are overwritten when identical attributes with different
values are configured. The configuration profile in permanent storage can be created via the web user interface or telnet
user interface, or other management protocols. The factory default configuration can be restored either by pushing the
reset button for more than five seconds until the power LED blinks or by clicking the Restore Default Configuration option
in the Restore Default Settings screen (see section 5.1.3).
•
•
•
•
•
•
•
2.2 TCP/IP Settings
It is likely that your computer will automatically obtain an IP Address and join the network. This is because the
Dynamic Host Configuration Protocol (DHCP) server (on the device) will start automatically when your Router
powers up.
This automatic assignment requires that DHCP is configured on your computers. It is likely that this is already the
case, but should you be required to configure this, please see the instructions below.
Windows XP
DHCP Mode
To set your PC for DHCP mode, check the Internet Protocol properties of your Local Area Connection. You can set
your PC to DHCP mode by selecting Obtain an IP address automatically in the dialog box shown below.
Web User Interface