User guide

29
Etisalat HSPA WiFi Router USER GUIDE
5.3 Configure SNMP agent on the 3G10WVE
The Simple Network Management Protocol (SNMP) allows a network administrator to monitor a network
by retrieving settings on remote network devices. To do this, the administrator typically runs an SNMP
management station program such as MIB browser on a local host to obtain information from the SNMP agent,
in this case the 3G10WVE (if SNMP enabled). An SNMP ‘community’ performs the function of authenticating
SNMP traffic. A ‘community name’ acts as a password that is typically shared among SNMP agents and
managers.
By default, SNMP agent is enabled on the Router.
Setting up SNMP agent
Open a web browser (IE/Firefox/Safari), type in LAN address of the Router (http://192.168.1.1 by default) to
log into the web interface.
The login username and password by default is admin/admin.
Go to Advanced Settings > SNMP. Enable SNMP agent and set up all options according to the screenshot
below.
Click Save/Apply to activate these settings.
•
•
•
•
5.4 Simple Network Time Protocol (SNTP)
This screen allows you to configure the time settings of your Router. To automatically synchronize with Internet
time servers, tick the box as illustrated below.
The following options should now appear (see screenshot below):
First NTP time server:
Select the required server.
Second NTP time server:
Select second time server, if required.
Time zone offset:
Select the local time zone.
Configure these options and then click Save/Apply to activate.
Management