User`s guide

HTML SET UP & DIAGNOSTIC
12 4,6 Mb/s point to point connection set-up
12.1 Overview
A point to point communication at a data rate of up to 4,6 Mb/s instead of
2,3 Mb/s can be provided with two twisted pairs.
An SHDSL connection is established at a data rate of up to 2,3 mob/s on
each twisted pair.
The data flow is automatically shared over the two pairs.
12.2 SHDSL ports set-up
Once the XSRINGs will have been
set up, they must be connected to
the line according to the drawing
opposite.
XSRING Nr1 XSRING Nr 2
Setting up the XSRING Nr 1
• Select the Ethernet & switching” menu and then the “SHDSL port” menu.
• Select the LTU checkbox for port 1 and port 2
• Select the data rate for port 1 and port 2 according to the table of the appendix 1.
Note : If the “auto” option is selected, it will cause the XSRING to try all the data rates.
The connection delay will be long. Moreover, the XSRING software will select a
cautious solution. It is why the “auto” option will be selected only if the distance
is short (less than, 1 Km).
• Select the “Signal power” value “Auto” for port 1 and port 2.
• Select the “SHDSL ports aggregation” checkbox.
• Save and click the reboot button.
Failsafe ring SHDSL switch User’s guide ref 9014809-03
Page 35