User`s guide

HTML SET UP & DIAGNOSTIC
Failsafe ring SHDSL switch User’s guide ref 9014809-03 Page 31
3. Routes must be created or the RIP protocol must be enabled.
A route is a table which registers which gateway address must be used to
transfer IP packets to a particular network.
For instance, referring to the drawing above, If the routing function has
been enabled in the XSRING Nr 1, and if IP packets have to be
transmitted from the IP network 1 to the IP network 2, a route has to be
created as follows :
Route name : “From NETWK 1 to NETWK 2”
Destination IP addr : “network 2 IP address”
Gateway IP addr : IP02
Remarks :
“Network 2 IP address” is the address of the network Nr 2; for instance
192.168.2.0.
IP02 is the address of the SHDSL interface of the XSRING Nr 2.
To enable the routing function and assign an IP @ to the SHDSL
interface,
• select the “IP protocol & routing” menu and then the “IP protocol” menu,
• Select the “Routing mode active” checkbox.
• Enter the IP address, netmask, and, eventually, default gateway assigned to the
SHDSL network.