User`s guide

HTML SET UP & DIAGNOSTIC
Page 26 User’s guide ref 9014809-03 Failsafe ring SHDSL switch
2 Enabling html configuration
Coming from factory, the DIP switches SW1 and SW2 are set OFF (ready
for html configuration); and the IP address of the XSRING is
192.168.0.128.
Check the DIP switches SW1 and SW2 are OFF.
Remark :
When the DIP switches SW1 and SW2 are OFF, the active IP address is
the stored IP address.
3 Connecting a PC to the XSRING for configuration
3.1 Overview
Administration server address :
The administration html server is located at the LAN IP address of the SHDSL switch (The
factory IP address is192.168.0.128).
First set up :
For the first configuration, we advise to connect the PC directly to the LAN interface of the
SHDSL switch..
Further set up modifications :
Modifications can be carried out from the LAN interface, or remotely through the line.
Restoring the factory IP address :
The factory IP address of the router on the LAN interface can be restored by setting the
DIP switches SW01 ON and SW02 OFF.
In that position of the DIP switches, the stored configuration is not deleted.
Setting the DIP switches in that position gives also a free access to the administration
server from the LAN interface.
During operations, the DIP switches must not be left in that position.
Network IP address :
Later in the text, we often speak of “network IP address”.
We mean the lowest value of the addresses of the network.
For instance, if the netmask of a network is 255.255.255.0, the network IP address of that
network is X.Y.Z.0.