User`s guide

SET UP
XSRING+ SHDSL switch User’s guide ref 9018809-01 Page 47
15 SNMP
15.1 Overview
The XSRING+ supports the following MIBS :
• RFC1213-MIB (MIB-2)
• HDSL2-SHDSL-LINE-MIB
• HOST-RESOURCES-MIB
• IF-MIB
• IP-MIB
• BRIDGE-MIB
• RSTP-MIB
The SNMP manager can acquire, in particular, the following information :
Ethernet 10/100 BT ports status : Up / down
SHDSL links status : connected or not
SHDSL links bit rate
SHDSL links SNR ratio margin
SHDSL links Number of erroneous seconds during the last quarter of hour
SHDSL links Number of erroneous seconds during the last 24 hours
RSTP ports status (blocked / learning / forwarding)
RSTP bridge parameters (bridge ID, priority, MAC, root)
MAC addresses data base
The XSRING+ is also able to send SNMP traps when the following events occur :
Ethernet 10/100 BT port connection
Ethernet 10/100 BT port disconnection
SHDSL connection established for each SHDSL port
SHDSL connection disconnected for each SHDSL port
Failsafe ring established
Failsafe ring failure
Product restart
15.2 Setting up the SNMP function
To enable the SNMP function,
• Select “Set up > System > SNMP”.
• Select the “Enable” checkbox.
“Manager IP address” parameter :
Enter the IP address of the SNMP manager
“Community name” parameter :
Enter the name of the community to which the XSRING+ belongs.
“System name” parameter :
The system name is the name of the product.
Enter a string which identifies the product reference; for instance XSRING+2400.
“System location” parameter :
Enter a string which identifies the location where the XSRING+ is installed.