User`s guide

SET UP
XSRING+ SHDSL switch User’s guide ref 9018809-01 Page 29
To enable the router function and assign an IP @ to the SHDSL interface of the XSRING+,
• select “Set up > IP protocol & routing > IP protocol”;
• select the “Router mode” checkbox;
• enter the IP address and netmask assigned to both SHDSL interfaces.
To register a route,
• select “IP protocol & routing > Static route ”;
• click the ”Add” button;
• Enter the parameters of the route.
To enable the RIP protocol instead of programming routes,
• select “IP protocol and routing > RIP”.
• Select the “Enable RIP” checkbox.