User`s guide

SET UP
XSRING+ SHDSL switch User’s guide ref 9018809-01 Page 27
2.3 Modifying the configuration from the LAN
Launch the html browser and enter the IP address assigned to the router.
Or, launch the ETICFINDER utility to detect the XSRING IP address.
Remark :
If the home page cannot be displayed, refer below.
3 Rebooting the XSRING+ after parameters changes
• After completing a page, click the « Save » button at the bottom of the page.
• After some parameters changes, the XSRING+ must restart.
When the configuration has been completely carried out, click the « Reboot » red button in the green
bar, when displayed.
• Once the product has restarted, check the « Reboot » button has disappeared from the green
bar.
To save the configuration file to a hard disk :
• Select the “maintenance” menu and then the “Save / restore” menu.
Click the “Save current configuration to disk” button.
4 Recovering the factory configuration
For any reason, it may be necessary to restore the factory configuration of the SHDSL switch.
Restoring temporarily the factory default configuration
When the push-button, located on the top of the product, is pressed, the default configuration is
temporarily restored. The IP address of the html server is 192.168.0.128.
However, the current configuration is not lost. The parameters of the current configuration are
displayed as usually.
Make the necessary changes, and Save.
Deleting the current configuration and restoring the factory default configuration
When the power is switched ON while the push-button is pressed, the current configuration is deleted
and the factory default configuration is restored.
5 Restricting access to the administration server
The access to the administration server can be protected by a login and password.
To protect access to the administration server,
• Select the “System” menu, and then the “Administration rights” menu.