User`s guide

INSTALLATION
XSRING+ SHDSL switch User’s guide ref 9018809-01 Page 15
Push-button :
A push-button is located close to the DIP switches.
It enables to restore the factory profile.
To restore the factory profile, switch the power on while pressing the push-button until the
OPERATION led turns green.
Attention : Once the factory profile has been restored, the stored configuration is lost.
2 positions screw terminal : Supply voltage 1
Protected against reverse polarity
Position Signal Function
1 Power 1 + 10-30 VDC : XSRING+2220 & XSRING+BP2220
10-60 VDC :
XSRING+2400 XSRING+2230 XSRING+BP2400 XSRING+BP2230
2 Power 1 - 0V isolated from the enclosure
2 positions screw terminal : Supply voltage 2
Protected against reverse polarity
Position Signal Function
1 Power 2 + 10-30 VDC : XSRING+2220 & XSRING+BP2220
10-60 VDC :
XSRING+2400 XSRING+2230 XSRING+BP2400 XSRING+BP2230
2 Power 2 - 0V isolated from the enclosure
4 positions screw terminal :Digital input and output
Position Signal Function
1 3V3 3 V DC provided by the XS+
2 In Digital input
3 F + Digital output + (max 50Vdc - 0,6A)
4 F - Digital output -
XSRING+2220 XSRING+2230 XSRING+2400
2 positions screw terminal : Shdsl 1 & Shdsl 2
Position Signal Function
1 Line SHDSL line conductor (the two wires can be inverted)
2 Line SHDSL line conductor (the two wires can be inverted)
XSRING+BP2220 XSRING+BP2230 XSRING+BP2400
2 positions screw terminal : Shdsl 1 & Shdsl 2
Position Signal Function
1 Line SHDSL line conductor if the by-pass function is not used
2 Line SHDSL line conductor if the by-pass function is not used
XSRING+BP2220 XSRING+BP2230 XSRING+BP2400
2 positions screw terminal : Shdsl 1 by-pass & Shdsl 2 by_pass
Position Signal Function
1 Line SHDSL line conductor if the by-pass function is used
2 Line SHDSL line conductor if the by-pass function is used
RJ45 connector : Ethernet
Position Signal Function
1 Tx + Emission polarity +
2 Tx - Emission polarity -
3 Rx + Reception polarity +
4 N.C -
5 N.C -
6 Rx - Reception polarity -
7 N.C. -
8 N.C. -