User`s guide

Configuration
Page 30 User’s guide ref 9014709-01 XSLAN shdsl switch
Each port will be usually set in the “auto” mode; however, if necessary, 10
Mb/s or 100 Mb/s and full or half duplex operations can be selected.
4.5 IP Protocol & routing menu
4.5.1 IP Protocol menu
Ethernet network
Enter the IP address, netmask and, if there is one, the default gateway
address.
Routing (except XSLAN-140)
It can be useful to enable the routing functions to avoid unnecessary traffic
over the shdsl link when the traffic is heavy on each Ethernet network.
In that case, an IP address has to be assigned to the SHDSL interface
(see below) and routes have to be entered (see below shdsl network and
also RIP and static routes).
SHDSL network (except XSLAN-140)
An IP address has to be assigned to the shdsl interface only it the router
function of the XSLAN has been enabled.