User`s guide

Configuration
Page 24 User’s guide ref 9014709-01 XSLAN shdsl switch
2.2 Configuration through the LAN
Case of a LAN with a BOOTP or DHCP server
Step 1 : Set the DIP switches SW1 OFF and SW2 OFF to select DHCP /
BOOTP operation.
Step 2 : Launch ETIC FINDER to detect the XSLAN over the LAN.
Click the product once detected.
The Home page of the administration server is displayed.
Note :
If the home page cannot be displayed, refer to paragraph 4 below.
Case of a LAN without BOOTP or DHCP server
That method must be avoided for the first configuration, because the
factory IP address of the XSLAN can also have been assigned to another
product.
Otherwise, launch the html browser and enter the IP address assigned to
the XSLAN.
Or, launch the ETICFINDER utility.
3 Wrong IP address or password
When launching the html browser, the homepage of the html server may
not be displayed; the cause may be the IP address you enter or the
password you use are wrong.
if the XSLAN IP address you enter is wrong, you can recover the
factory IP address by setting SW01 ON and SW2 OFF.
The factory IP address 192.168.0.128 will be restored as long as the
SW01 micro-switch will be left ON. Once, SW01 will be set OFF, the
stored IP address (the IP address which is displayed) will be used by the
product.