User`s guide

Configuration
Page 22 User’s guide ref 9014709-01 XSLAN shdsl switch
1.2 Inverse-multiplexing
??Point to point
Set the SW6 and SW7
OFF.
??Inverse-multiplexing
The data rate will be twice
what it would be with only 1
pair (2 wires).
Moreover, in case of a break of
1 line, the other line will backup
the transmission.
Set SW6 ON and SW7 ON
2 Connecting a PC to the XSLAN for configuration
If the product is coming from factory, we advise to configure the XSLAN by
connecting directly the PC to one of the RJ45 ports (see paragraph 3.1).
2.1 Configuring with a PC connected to the XSLAN Ethernet interface
Step 1 : Check the DIP switches SW1 and SW2; they must be set to OFF
and OFF to select the stored IP address, or, if necessary, to ON and OFF
to restore the factory IP address.
Coming from factory, the DIP switches SW1 and SW2 are set OFF (ready
for configuration); and the IP address of the XSLAN is 192.168.0.128.
Step 2 : Create or modify the PC TCP/IP connection
Assign to the PC an IP @ in accordance with the XSLAN IP address.
For the first configuration, assign or instance 192.168.0.127 to the PC.
Step 3 : Connect the PC directly
to an XSLAN ethernet interface
using any Ethernet cable (straight or
crosswired)