User guide
Table Of Contents
- 1 Security recommendations
- 2 CERTIFICATE OF CONFORMITY
- 3 Products identification
- 4 Data-sheet
- 5 Product overview
- 1 Dimensions
- 2 Connectors
- 3 Led indicators
- 4 DIP switches
- 5 Factory default push-button
- 6 Mounting the product on a DIN rail or removing it
- 7 Cooling
- 8 RS232 interface
- 9 RS485 interface
- 10 Digital input and output
- 11 Connecting the antenna
- 12 Installing the SIM card
- Set up steps
- 2 Connecting a PC to the router for configuration
- 3 Rebooting the router after parameters changes
- 4 Recovering the factory LAN IP address
- 5 Recovering the factory configuration
- 6 Restricting access to the administration server
- 7 Recovering a free access to the administration server
- 8 Factory configuration
- 9 LAN interface set up
- 10 UMTS – GSM-GPRS-3GDGE interface set up
- 11 Setting up the DynDNS service
- 12 Creating VPN connections between routers
- 13 Routing functions
- 14 Address and port translation
- 15 VRRP redundancy
- 16 Remote users connections service
- 17 Remote users connections
- 18 M2Me_Connect service
- 19 Users list
- 20 Firewall
- 21 Serial to IP gateway
- 22 USB to IP gateway
- 23 Advanced functions
- 1 Diagnostic menu
- 2 Saving the configuration to a file
- 3 Updating the firmware
- Signets Word
DIAGNOSTIC & MAINTENANCE
Page 86 User guide ref 9020009-01 UMTS GPRS EDGE router ref. RAS-3G
3 Updating the firmware
Step 1 : Before starting, you need,
A PC with a Web browser.
An Ethernet cable or a switch
The FTP server software which can be downloaded from the « firmware page » of the ETIC «
download area » web server.
Step 2 : Download the release of the firmware from our download area to your PC
Step 3 : Prepare the PC
Check the Ip address of the PC is compatible with the one of the router.
Connect the router to the PC.
Launch the TFTP server (tftp32.exe) software and select the new release (L026xxx/img) by using the
"Browser" button.
Click on "Show dir" to check the files of the directory : rfsmini.tgz, rootfs.bin, u-boot.bin and uImage.
Step 4 : Update the firmware
Launch the web browser
Enter the IP address of the ETIC product ; the home page of the ETIC configuration server is
displayed.
Select the "System" menu and then " firmware Update". In the field "IP address of the TFTP server",
enter the IP address of your PC.
Note : The IP address of the PC is written in the field "Server Interface" in the TFTP server windows.
Click "Save" and then "Update".
The first file should begin to be downloaded from the PC to the router.
During the operation, the led blinks
When the download is finished, the product automatically reboots.
Check the new release has been installed, go to "About" in the administration web page of the IP
product.