User guide
Table Of Contents
- 1 Security recommendations
- 2 CERTIFICATE OF CONFORMITY
- 3 Products identification
- 4 Data-sheet
- 5 Product overview
- 1 Dimensions
- 2 Connectors
- 3 Led indicators
- 4 DIP switches
- 5 Factory default push-button
- 6 Mounting the product on a DIN rail or removing it
- 7 Cooling
- 8 RS232 interface
- 9 RS485 interface
- 10 Digital input and output
- 11 Connecting the antenna
- 12 Installing the SIM card
- Set up steps
- 2 Connecting a PC to the router for configuration
- 3 Rebooting the router after parameters changes
- 4 Recovering the factory LAN IP address
- 5 Recovering the factory configuration
- 6 Restricting access to the administration server
- 7 Recovering a free access to the administration server
- 8 Factory configuration
- 9 LAN interface set up
- 10 UMTS – GSM-GPRS-3GDGE interface set up
- 11 Setting up the DynDNS service
- 12 Creating VPN connections between routers
- 13 Routing functions
- 14 Address and port translation
- 15 VRRP redundancy
- 16 Remote users connections service
- 17 Remote users connections
- 18 M2Me_Connect service
- 19 Users list
- 20 Firewall
- 21 Serial to IP gateway
- 22 USB to IP gateway
- 23 Advanced functions
- 1 Diagnostic menu
- 2 Saving the configuration to a file
- 3 Updating the firmware
- Signets Word
SET UP
UMTS GPRS EDGE router ref. RAS-3G User guide ref. 9020009-01 Page 73
21 Serial to IP gateway
That function is available in RAS-3G-1220 or RAS-3G-1230
The RAS-3G features two serial asynchronous ports RS232 or RS485 (see the product identification
table).
A serial gateway can be assigned to each port .
If the same type of gateway is assigned to both serial ports, the UDP or TCP port numbers must be
different.
The gateways listed below are provided :
Modbus client or server (i.e. master or slave)
To connect several serial modbus slaves to several IP modbus clients.
Or to connect a serial modbus master to an IP modbus server.
RAW TCP server or client :
To connect 2 serial devices through an IP network.
RAW UDP :
To exchange serial data between several serial and IP devices, through an IP network, using a table
of IP addresses.
Telnet :
To connect a Telnet terminal to the RAS.
Unitelway slave :
To connect a serial unitelway master to an IP network.