User guide
Table Of Contents
- 1 Security recommendations
- 2 CERTIFICATE OF CONFORMITY
- 3 Products identification
- 4 Data-sheet
- 5 Product overview
- 1 Dimensions
- 2 Connectors
- 3 Led indicators
- 4 DIP switches
- 5 Factory default push-button
- 6 Mounting the product on a DIN rail or removing it
- 7 Cooling
- 8 RS232 interface
- 9 RS485 interface
- 10 Digital input and output
- 11 Connecting the antenna
- 12 Installing the SIM card
- Set up steps
- 2 Connecting a PC to the router for configuration
- 3 Rebooting the router after parameters changes
- 4 Recovering the factory LAN IP address
- 5 Recovering the factory configuration
- 6 Restricting access to the administration server
- 7 Recovering a free access to the administration server
- 8 Factory configuration
- 9 LAN interface set up
- 10 UMTS – GSM-GPRS-3GDGE interface set up
- 11 Setting up the DynDNS service
- 12 Creating VPN connections between routers
- 13 Routing functions
- 14 Address and port translation
- 15 VRRP redundancy
- 16 Remote users connections service
- 17 Remote users connections
- 18 M2Me_Connect service
- 19 Users list
- 20 Firewall
- 21 Serial to IP gateway
- 22 USB to IP gateway
- 23 Advanced functions
- 1 Diagnostic menu
- 2 Saving the configuration to a file
- 3 Updating the firmware
- Signets Word
SET UP
20.2.2 Configuring the main filter
Select the “Security” menu and then “Firewall” and “Main filter”.
The “Main filter” page is divided in two parts :
WAN traffic rules :
The first part, entitled “WAN” traffic rules, is made to define how the IP packets not carried in a VPN,
have to be filtered.
VPN traffic rules :
The second part, entitled “VPN traffic rules” allows to define how the IP packets carried inside the
VPNs have to be filtered.
Configure successively the WAN traffic rules using the same method.
Step 1 : Select the default policy
“LAN to WAN” parameter
:
That parameter sets what the filter will decide if an IP packet coming from the LAN does not match
any f the rules of the filter :
If the value “Accept” is selected, the IP packet will be transmitted to the VPN.
If the value “Drop” is selected, the IP packet will be rejected.
“WAN to LAN” parameter
:
That parameter sets what the filter will decide if an IP packet coming from the WAN does not match
any f the rules of the filter :
If the value “Accept” is selected, the IP packet will be transmitted to the LAN.
If the value “Drop” is selected, the IP packet will be rejected.
Page 68 User guide ref 9020009-01 UMTS GPRS EDGE router ref. RAS-3G