User guide

SET UP
UMTS GPRS EDGE router ref. RAS-3G User guide ref. 9020009-01 Page 63
18.2 Configuring a M2Me_Connect connection
Step 1 : Router configuration
• Select the « Setup» menu, the « Remote users » menu, the “M2Me_Connect” menu, and
then the “Connection” menu.
« Activate » parameter:
Select the checkbox
“TCP ports” and “UDP ports” parameters :
Select the protocol (UDP and or TCP) and the ports numbers the router must check to set a
connection to the M2Me_Connect service.
We advise to select only the TCP protocol because providers sometimes forbid UDP to avoid
unsolicited frames coming from the internet to the antenna of the router.
• Test the connection
Click the “Control” menu, and press the “connect now” button.
Go to the ”Diagnostic” menu, “Network status” menu and then “M2Me”.
When the connection between the router and the M2Me_Connect service is established, the port
number and protocol are displayed.
• Deselect the ports numbers needlessly selected
If too many ports have been selected, the connection delay may be long; it is why, we advise to
unselect all the ports except the one which has finally been successful.
Step 2 : M2Me_Secure software configuration (PC side)
• Click « Menu » and then « New site ». The Site configuration window is displayed.
• Select the « General » tab and enter a site name.
• Select the « Connection » tab; select the option “That site can be reached through the Internet
and the “M2Me_Connect” option.
• Enter the product key of the router; it can be pasted from the “About” menu of the router.