User guide
Table Of Contents
- 1 Security recommendations
- 2 CERTIFICATE OF CONFORMITY
- 3 Products identification
- 4 Data-sheet
- 5 Product overview
- 1 Dimensions
- 2 Connectors
- 3 Led indicators
- 4 DIP switches
- 5 Factory default push-button
- 6 Mounting the product on a DIN rail or removing it
- 7 Cooling
- 8 RS232 interface
- 9 RS485 interface
- 10 Digital input and output
- 11 Connecting the antenna
- 12 Installing the SIM card
- Set up steps
- 2 Connecting a PC to the router for configuration
- 3 Rebooting the router after parameters changes
- 4 Recovering the factory LAN IP address
- 5 Recovering the factory configuration
- 6 Restricting access to the administration server
- 7 Recovering a free access to the administration server
- 8 Factory configuration
- 9 LAN interface set up
- 10 UMTS – GSM-GPRS-3GDGE interface set up
- 11 Setting up the DynDNS service
- 12 Creating VPN connections between routers
- 13 Routing functions
- 14 Address and port translation
- 15 VRRP redundancy
- 16 Remote users connections service
- 17 Remote users connections
- 18 M2Me_Connect service
- 19 Users list
- 20 Firewall
- 21 Serial to IP gateway
- 22 USB to IP gateway
- 23 Advanced functions
- 1 Diagnostic menu
- 2 Saving the configuration to a file
- 3 Updating the firmware
- Signets Word
SET UP
Page 60 User guide ref 9020009-01 UMTS GPRS EDGE router ref. RAS-3G
”Port number”
& “Protocol” :
Select the port Nr and the type of level 3 protocol used to transport the TLS VPN; UDP will be
preferred.
Attention :
The selected port number assigned to the remote users connections must be different from the one
used for VPN connections between routers if such VPN connections have been configured.
“Remote Users authentication” parameters
:
Authentication an encryption can be carried-out with a pre-shared key or a certificate.
If the “Login/password” is selected, the remote user is authenticated with a login and a
password.
If the “Login/password and Certificate” value is selected, the remote PC is authenticated with
the certificate and the user with a login and password. In that case, the PC certificate must be
stored in the user list.
«Encryption algorithm» & «Message digest algorithm» parameters :
Leave the default values.
Step 2 : Configure the M2Me_Secure software
For detailed information, report to the M2Me_Secure manual.
• Click « Menu » and then « New site ». The Site configuration window is displayed.
• Select the « General » tab and enter a site name.
• Select the « Connection » tab; select the option “That site can be reached through the Internet.
• In the field « Host name or IP address », select the router IP address or DynDNS name or DNS
name.
• Select the « Advanced tab » ; select the level 3 protocol (UDP or TCP), the port number and the
encryption algorithm.
These parameters must have the same values must in the PC and in the router.