User guide

Table Of Contents
SET UP
12.3 TLS VPN connections
12.3.1 Configuring the TLS-SSL protocol
Select the “Setup” menu, the “network” menu and then the ‘VPN connections” menu.
Select the “TLS” VPN type and click “Properties” .
“Port number”
& “protocol” parameters :
Select the port Nr and the type of level 3 protocol used to transport the TLS VPN; UDP will be
preferred.
Attention : The port number value must be different from the one used by remote users.
“VPN network address”
& “VPN network netmask” parameters :
The TLS VPN server router assigns automatically an IP address to the VPN client router.
That VPN IP address must not be confused with the WAN interface IP address.
Attention :
The VPN IP network address field must be different from the WAN network IP address .
The number of VPN addresses cannot be greater than 255; the netmask cannot exceed
255.255.255.0.
VPN network
IP address
(default 172.16.1.0 )
TLS VPN
INTERNET
3G
LAN IP
addr.
Remote LAN IP
addr.
IP network
GPRS
UMTS GPRS EDGE router ref. RAS-3G User guide ref. 9020009-01
Page 43