User guide
Table Of Contents
- 1 Security recommendations
- 2 CERTIFICATE OF CONFORMITY
- 3 Products identification
- 4 Data-sheet
- 5 Product overview
- 1 Dimensions
- 2 Connectors
- 3 Led indicators
- 4 DIP switches
- 5 Factory default push-button
- 6 Mounting the product on a DIN rail or removing it
- 7 Cooling
- 8 RS232 interface
- 9 RS485 interface
- 10 Digital input and output
- 11 Connecting the antenna
- 12 Installing the SIM card
- Set up steps
- 2 Connecting a PC to the router for configuration
- 3 Rebooting the router after parameters changes
- 4 Recovering the factory LAN IP address
- 5 Recovering the factory configuration
- 6 Restricting access to the administration server
- 7 Recovering a free access to the administration server
- 8 Factory configuration
- 9 LAN interface set up
- 10 UMTS – GSM-GPRS-3GDGE interface set up
- 11 Setting up the DynDNS service
- 12 Creating VPN connections between routers
- 13 Routing functions
- 14 Address and port translation
- 15 VRRP redundancy
- 16 Remote users connections service
- 17 Remote users connections
- 18 M2Me_Connect service
- 19 Users list
- 20 Firewall
- 21 Serial to IP gateway
- 22 USB to IP gateway
- 23 Advanced functions
- 1 Diagnostic menu
- 2 Saving the configuration to a file
- 3 Updating the firmware
- Signets Word
SET UP
UMTS GPRS EDGE router ref. RAS-3G User guide ref. 9020009-01 Page 33
10.3 “Control” menu
The RAS-3G router may not detect that the 3G connection has been cleared ; it is why, the router can
send a periodical PING to a particular address.
If one that PING does not receive an answer, and after several retries, the 3G connection is reset by
the RAS-3G router.
• To set-up that function, select the « Configuration» menu and then « WAN interface» and then
“Control”.
“Enable the ping control” checkbox
:
select that checkbox.
“IP address to ping” parameter
:
Enter the IP address of the server to which the RAS-3G will transmit periodically a PING to control the
connection works correctly.
“Ping period” parameter
:
Enter the value of the period of the PINGS.
“Ping retries” parameter
:
If a PING does not receive an answer, the router will repeat PINGS at a high frequency. If that high
frequency PINGS do not receive an answer after a certain number of retries, the connection is reset.
Enter the number of times the router has to repeat the PING request at a high frequency before
declaring the connection in failure.