User guide
Table Of Contents
- 1 Security recommendations
- 2 CERTIFICATE OF CONFORMITY
- 3 Products identification
- 4 Data-sheet
- 5 Product overview
- 1 Dimensions
- 2 Connectors
- 3 Led indicators
- 4 DIP switches
- 5 Factory default push-button
- 6 Mounting the product on a DIN rail or removing it
- 7 Cooling
- 8 RS232 interface
- 9 RS485 interface
- 10 Digital input and output
- 11 Connecting the antenna
- 12 Installing the SIM card
- Set up steps
- 2 Connecting a PC to the router for configuration
- 3 Rebooting the router after parameters changes
- 4 Recovering the factory LAN IP address
- 5 Recovering the factory configuration
- 6 Restricting access to the administration server
- 7 Recovering a free access to the administration server
- 8 Factory configuration
- 9 LAN interface set up
- 10 UMTS – GSM-GPRS-3GDGE interface set up
- 11 Setting up the DynDNS service
- 12 Creating VPN connections between routers
- 13 Routing functions
- 14 Address and port translation
- 15 VRRP redundancy
- 16 Remote users connections service
- 17 Remote users connections
- 18 M2Me_Connect service
- 19 Users list
- 20 Firewall
- 21 Serial to IP gateway
- 22 USB to IP gateway
- 23 Advanced functions
- 1 Diagnostic menu
- 2 Saving the configuration to a file
- 3 Updating the firmware
- Signets Word
SET UP
UMTS GPRS EDGE router ref. RAS-3G User guide ref. 9020009-01 Page 29
Remark : The stored configuration will be lost; the factory IP address 192.168.0.128 will be restored.
6 Restricting access to the administration server
When the RAS-3G comes from factory, the html server is not protected by a password.
It is advised to protect the access to the administration server with a login and a password.
To protect access to the administration server,
• Select the “Setup” menu, the “Security” menu and then the “Administration menu”.
Remark : For more simplicity, we advise to chose the login and the password of one of the remote
users stored in the user list.
7 Recovering a free access to the administration server
If the Login & or password entered to reach the administration server have been rejected, it is
possible to recover a free access to the administration server from the LAN only, by setting SW01 ON
and SW2 OFF.
Remark :
The factory IP address 192.168.0.128 will also automatically be restored as long as SW01 will remain
ON and SW2 OFF.
During normal operations SW01 and SW02 must not be left in that position.
8 Factory configuration
Coming from factory, the router configuration is as follows :
LAN IP @ 192.168.0.128
WAN IP @ None
Default user : Login = admin ; Password = admin
Admin. Web server restriction : None
Firewall :
Remote user filters Authorises any remote users belonging to the user list to reach a LAN IP address using a
PPTP or TLS connection
Main filter IP frames coming from the WAN interface to the LAN are dropped
IP frames transported inside a VPN are forwarded