User guide
Table Of Contents
- 1 Security recommendations
- 2 CERTIFICATE OF CONFORMITY
- 3 Products identification
- 4 Data-sheet
- 5 Product overview
- 1 Dimensions
- 2 Connectors
- 3 Led indicators
- 4 DIP switches
- 5 Factory default push-button
- 6 Mounting the product on a DIN rail or removing it
- 7 Cooling
- 8 RS232 interface
- 9 RS485 interface
- 10 Digital input and output
- 11 Connecting the antenna
- 12 Installing the SIM card
- Set up steps
- 2 Connecting a PC to the router for configuration
- 3 Rebooting the router after parameters changes
- 4 Recovering the factory LAN IP address
- 5 Recovering the factory configuration
- 6 Restricting access to the administration server
- 7 Recovering a free access to the administration server
- 8 Factory configuration
- 9 LAN interface set up
- 10 UMTS – GSM-GPRS-3GDGE interface set up
- 11 Setting up the DynDNS service
- 12 Creating VPN connections between routers
- 13 Routing functions
- 14 Address and port translation
- 15 VRRP redundancy
- 16 Remote users connections service
- 17 Remote users connections
- 18 M2Me_Connect service
- 19 Users list
- 20 Firewall
- 21 Serial to IP gateway
- 22 USB to IP gateway
- 23 Advanced functions
- 1 Diagnostic menu
- 2 Saving the configuration to a file
- 3 Updating the firmware
- Signets Word
SET UP
UMTS GPRS EDGE router ref. RAS-3G User guide ref. 9020009-01
Page 25
1 Set up steps
To configure the router, we advise to proceed as follows :
• Connecting a PC to the router
• Setting up the LAN interface
• Setting up the WAN interface
• Setting up the DynDNS service
• Setting up VPNs
• Setting up routing and IP address translation functions
• Setting up address translation and port forwarding
• Setting up remote users connections and the M2Me_Connect service
• Setting up the remote users list
• Setting up the serial gateway or the USB gateway
• Setting up the firewall
The RAS-3G router is configured with a PC and an HTML browser.
2 DIP switches enable you to set the IP address : Factory address, stored address, BootP or DHCP
client or server.
For the first configuration, we advise to connect the PC directly to the router Ethernet interface.
Modifications can be carried out through the LAN or remotely.