User guide
Table Of Contents
- 1 Security recommendations
- 2 CERTIFICATE OF CONFORMITY
- 3 Products identification
- 4 Data-sheet
- 5 Product overview
- 1 Dimensions
- 2 Connectors
- 3 Led indicators
- 4 DIP switches
- 5 Factory default push-button
- 6 Mounting the product on a DIN rail or removing it
- 7 Cooling
- 8 RS232 interface
- 9 RS485 interface
- 10 Digital input and output
- 11 Connecting the antenna
- 12 Installing the SIM card
- Set up steps
- 2 Connecting a PC to the router for configuration
- 3 Rebooting the router after parameters changes
- 4 Recovering the factory LAN IP address
- 5 Recovering the factory configuration
- 6 Restricting access to the administration server
- 7 Recovering a free access to the administration server
- 8 Factory configuration
- 9 LAN interface set up
- 10 UMTS – GSM-GPRS-3GDGE interface set up
- 11 Setting up the DynDNS service
- 12 Creating VPN connections between routers
- 13 Routing functions
- 14 Address and port translation
- 15 VRRP redundancy
- 16 Remote users connections service
- 17 Remote users connections
- 18 M2Me_Connect service
- 19 Users list
- 20 Firewall
- 21 Serial to IP gateway
- 22 USB to IP gateway
- 23 Advanced functions
- 1 Diagnostic menu
- 2 Saving the configuration to a file
- 3 Updating the firmware
- Signets Word
INSTALLATION
12 Installing the SIM card
Before installing the SIM card into the router, its PIN code must have been cleared.
The PIN code can be cleared using a usual telephone or a smart phone.
Step 1 : Install the SIM card
• Power off the router.
• Remove the anti-steal lid at the top of the product
• Press the SIM card eject button and remove the SIM card drawer.
• Insert the SIM card SIM card drawer.
• Slid the drawer back into the unit and make sure it locks into place.
Step 2 : Check the reception signal strength
• Switch-on the router
• The led first lights red and then green.
• The power indicator lights green.
• The reception led flashes to indicate cyclically the reception signal strength.
The reception led must flash at least 2 times to ensure a reliable connection.
If the reception led flashes only one time, the reception is poor ; it must be improved otherwise the
connection will be probably not reliable.
If the reception led remains OFF, it means that the 3G service cannot be received at that location or
that the antenna is not correctly connected or is damaged.
• If the led lights red, it signifies that the PIN code of the SIM card has not been cleared.
Page 24 User guide ref 9020009-01 UMTS GPRS EDGE router ref. RAS3G