User guide
Table Of Contents
- 1 Security recommendations
- 2 CERTIFICATE OF CONFORMITY
- 3 Products identification
- 4 Data-sheet
- 5 Product overview
- 1 Dimensions
- 2 Connectors
- 3 Led indicators
- 4 DIP switches
- 5 Factory default push-button
- 6 Mounting the product on a DIN rail or removing it
- 7 Cooling
- 8 RS232 interface
- 9 RS485 interface
- 10 Digital input and output
- 11 Connecting the antenna
- 12 Installing the SIM card
- Set up steps
- 2 Connecting a PC to the router for configuration
- 3 Rebooting the router after parameters changes
- 4 Recovering the factory LAN IP address
- 5 Recovering the factory configuration
- 6 Restricting access to the administration server
- 7 Recovering a free access to the administration server
- 8 Factory configuration
- 9 LAN interface set up
- 10 UMTS – GSM-GPRS-3GDGE interface set up
- 11 Setting up the DynDNS service
- 12 Creating VPN connections between routers
- 13 Routing functions
- 14 Address and port translation
- 15 VRRP redundancy
- 16 Remote users connections service
- 17 Remote users connections
- 18 M2Me_Connect service
- 19 Users list
- 20 Firewall
- 21 Serial to IP gateway
- 22 USB to IP gateway
- 23 Advanced functions
- 1 Diagnostic menu
- 2 Saving the configuration to a file
- 3 Updating the firmware
- Signets Word
INSTALLATION
9 RS485 interface
The RS485 serial interface is provided on the front panel 2 pins
screw-block.
The RS485 serial interface is provided on the front panel 2 pins
screw-block.
Polarisation resistors
1 Kohm bus polarisation resistors are included inside the product.
Polarisation resistors
1 Kohm bus polarisation resistors are included inside the product.
-
1K 1K
+
SW1
B(+) A(-)RS485
RS485 line adaptation
For a several meters long connection over the RS485 local interface, it is not necessary to adapt the RS485 line. For a longer
distance, connect a 120 Ohm resistor at each end of the line.
RS485 line adaptation
For a several meters long connection over the RS485 local interface, it is not necessary to adapt the RS485 line. For a longer
distance, connect a 120 Ohm resistor at each end of the line.
10 Digital input and output
Digital output :
Max. voltage : 48 VDC
Max. current : 500 mA
Digital input :
Maximum voltage : 20 VDC
F+ F-
7
8
Digital output
+
-
V < 48 VDC
I < 0,5 A
3V3
In
5
6
Digital input
I max = 0,5 A
V
IPL router
11 Connecting the antenna
If the cabinet in which the router has to be installed is made of metal, the antenna has to be installed outside the cabinet; for
instance on its top.
The antenna must be ordered separately; the models below are available :
• 90 ° antenna (ANT210 ).
• Magnet mount antenna (ANT211)
• Roof antenna (ANT212)
ANT211 ANT212 (1,50 m)
UMTS GPRS EDGE router ref. RAS-3G User guide ref. 9020009-01
Page 23