User guide
Table Of Contents
- 1 Security recommendations
- 2 CERTIFICATE OF CONFORMITY
- 3 Products identification
- 4 Data-sheet
- 5 Product overview
- 1 Dimensions
- 2 Connectors
- 3 Led indicators
- 4 DIP switches
- 5 Factory default push-button
- 6 Mounting the product on a DIN rail or removing it
- 7 Cooling
- 8 RS232 interface
- 9 RS485 interface
- 10 Digital input and output
- 11 Connecting the antenna
- 12 Installing the SIM card
- Set up steps
- 2 Connecting a PC to the router for configuration
- 3 Rebooting the router after parameters changes
- 4 Recovering the factory LAN IP address
- 5 Recovering the factory configuration
- 6 Restricting access to the administration server
- 7 Recovering a free access to the administration server
- 8 Factory configuration
- 9 LAN interface set up
- 10 UMTS – GSM-GPRS-3GDGE interface set up
- 11 Setting up the DynDNS service
- 12 Creating VPN connections between routers
- 13 Routing functions
- 14 Address and port translation
- 15 VRRP redundancy
- 16 Remote users connections service
- 17 Remote users connections
- 18 M2Me_Connect service
- 19 Users list
- 20 Firewall
- 21 Serial to IP gateway
- 22 USB to IP gateway
- 23 Advanced functions
- 1 Diagnostic menu
- 2 Saving the configuration to a file
- 3 Updating the firmware
- Signets Word
INSTALLATION
Page 22 User guide ref 9020009-01 UMTS GPRS EDGE router ref. RAS3G
7 Cooling
To avoid obstructing the airflow around the unit, the spacing must be at least 25 mm above and below,
and 10 mm left and right.
8 RS232 interface
The RS232 data rate can be set from 1200 to 115200 b/s with parity (even / odd) or no parity.
The data terminal must be less than 10 meters far from the modem.
Cables can be provided to connect the product to DTE and DCE as follows :
RS232 cables (L=1m)
Code User
connector
Cable function
CAB592 SubD 9 male To connect a DCE to the RAS-3G
CAB593 SubD 9
female
To connect a DTE to the RAS-3G
CAB609 Wires To connect a device providing a specific connector
CAB593 cable - DB9 female RS232 connector
Position Circuit Name RAS - Terminal
1 CD 109 Carrier detect
⇒
2 RD 104 Data Reception
⇒
3 TD 103 Data Emission
⇐
4 DTR 108 Data terminal ready
⇐
5 GND 102 Ground
6 DSR 107 Data set ready
⇒
7 RTS 105 Request to send
⇐
8 CTS 106 Clear to send
⇒
9 RI 125 Ring indicator
⇒
CAB592 cable - DB9 male RS232 connector
Position Circuit Name RAS - Terminal
1 CD 109
⇐
2 RD 104 Data Reception
⇐
3 TD 103 Data Emission
⇒
4 DTR 108 Data terminal ready
⇒
5 GND 102 Ground
6 DSR 107 Data set ready
⇐
7 RTS 105 Request to send
⇒
8 CTS 106 Clear to send
⇐
9 RI 125 Ring indicator
⇐