User guide
Table Of Contents
- 1 Security recommendations
- 2 CERTIFICATE OF CONFORMITY
- 3 Products identification
- 4 Data-sheet
- 5 Product overview
- 1 Dimensions
- 2 Connectors
- 3 Led indicators
- 4 DIP switches
- 5 Factory default push-button
- 6 Mounting the product on a DIN rail or removing it
- 7 Cooling
- 8 RS232 interface
- 9 RS485 interface
- 10 Digital input and output
- 11 Connecting the antenna
- 12 Installing the SIM card
- Set up steps
- 2 Connecting a PC to the router for configuration
- 3 Rebooting the router after parameters changes
- 4 Recovering the factory LAN IP address
- 5 Recovering the factory configuration
- 6 Restricting access to the administration server
- 7 Recovering a free access to the administration server
- 8 Factory configuration
- 9 LAN interface set up
- 10 UMTS – GSM-GPRS-3GDGE interface set up
- 11 Setting up the DynDNS service
- 12 Creating VPN connections between routers
- 13 Routing functions
- 14 Address and port translation
- 15 VRRP redundancy
- 16 Remote users connections service
- 17 Remote users connections
- 18 M2Me_Connect service
- 19 Users list
- 20 Firewall
- 21 Serial to IP gateway
- 22 USB to IP gateway
- 23 Advanced functions
- 1 Diagnostic menu
- 2 Saving the configuration to a file
- 3 Updating the firmware
- Signets Word
INSTALLATION
3 Led indicators
Indicator Status Description
All models
Flashing green
until connection to
the 3G network
After power-on, and during 30 seconds, the reception signal
strength is indicated by the number of flashes.
See the table below.
Remark : The diagnostic menu reports the value (dBm) of the
reception signal.
Line /
Green
Then , when the router is connected to the 3G network, this led is
lit.
Green The supply voltage is present
Green The unit is ready
Red
The product is starting
The SIM card is not present
The hardware is in failure
RAS-3G-1220 (with 1 RS232 and 1 RS485 interface)
Rx Flashing green Bytes received from the RS232 or RS485 (to RAS)
Tx Flashing green Bytes transmitted to the RS22 or RS485 (from RAS)
RAS-3G-1230 (with 2 RS232 interfaces)
Rx Flashing green Bytes received from the RS232 –1 interface (to RAS)
Tx Flashing green Bytes transmitted to the RS22 –1 interface (from RAS)
Rx Flashing green Bytes received from the RS232 –2 interface (to RAS)
Tx Flashing green Bytes transmitted to the RS22 –2 interface (from RAS)
RF reception signal strength indicator
Descriptio
n
Status
RF Reception dBm
(Diagnostic menu)
3 flashes
Good reception
-50 to - 80
2 flashes
Sufficient reception
The level of the reception signal is sufficient to set a connection.
However, some error may occur which might decrease the data
rate.
-81 to –90
1 flash
Insufficient reception
The level of the reception signal is weak ; errors and disconnection
might occur.
The reception conditions must be improved to get a reliable
connection
-91 to -110
Always OFF No reception
Control or replace the antenna or the product itself.
Can a communication be set with a mobile phone ?
< -111
Always ON The router is now connected to the 3G-GSM network
Page 20 User guide ref 9020009-01 UMTS GPRS EDGE router ref. RAS3G