User manual

CONFIGURATION
11.3 RAW TCP gateway
The RAW TCP gateway can be assigned to the serial port 1 or to the
serial port 2 or to both.
if it is assigned to both serial ports, the TCP port numbers must be different.
11.3.1 Raw client gateway
The RAW client gateway can be used if a serial “master” device has to
send requests to one slave device (also called server) located on the IP
network.
The server can be either an ETIC gateway or a PC including a software
TCP server.
• Select the “transparent” and then the “raw client COM1” or the “raw
client COM2” menu .
• Enable the raw client gateway; and set up the parameters as follows :
“RS232/485 input buffer size”
parameter :
Set up the maximum length of an asynchronous string the gateway will
store before transmitting it to the IP network.
“Timeout of RS232/485 end of frame” parameter
:
Set up the delay the gateway will wait before declaring complete a string received from the
asynchronous device.
Once declared complete, the gateway will transmit the string to the IP network.
IPRS serial gateway User guide ref. 9018409-01
Page 31