User manual

CONFIGURATION
Page 22 User guide ref. 9018409-01 IPRS serial gateway
6 Recovering the factory LAN IP address
When launching the html browser, the homepage of the html server may
not be displayed; the cause may be the IP address you entered was
wrong.
if the IP address you enter is wrong, you can recover the factory IP
address by setting SW01 ON and SW2 OFF.
The factory IP address 192.168.0.128 will be restored as long as the
SW01 and SW02 micro switch will be left in that position.
Remark :
The SW01 and SW02 must not be left in that position during operations.
7 Recovering the factory configuration
If firewall rules have been created finally preventing from reaching any IP
address on the LAN interface including the serial gateway itself, it may be
necessary to restore the factory configuration of the serial gateway.
To restore the IPRS gateway factory configuration,
• Switch OFF the power supply of IPRS gateway.
• Press the push button on the top part of the IPRS gateway and switch
ON the power supply.
• Keep the push button pressed until the operation led turns red.
Remark : The stored configuration will be lost; the factory IP address
192.168.0.128 will be restored.
8 Restricting access to the administration server
The access to the administration server can be protected by a login and
password.
To protect access to the administration server,
• Select the “Setup” menu, the “Security” menu and then the
“Administration menu”.
Remark : For more simplicity, we advise to chose the login and the
password of one of the remote users stored in the user list.