Installation Guide

4
NOTE:
Recessed Installation in Grid Ceiling
1
from ceiling with LED Panel
□ Remo
Installation
Select a suitable location that can support the weight of the fixture. Determine the method of mounting before beginning installation.
WARNING: RISK OF ELECTRIC SHOCK. Ensure the electricity to the wires you are working on is shut off. Either remove the fuse or turn off the
circuit breaker before removing the existing light fixture or installing the new one.
With power disconnected to your electrical box, remove the existing fixture. Make a sketch of how the current fixture is wired (by wire color)
or mark the wires with masking tape and a pencil so you will know how to properly reconnect the wires to the new LED light fixture.
2
□ Use earthquake proof hook to secure LED panel
into the ceiling grid
earthquake proof hook
B
a
b
c
90°
90°
DIM+/- and LED +/- can not contact together, otherwise it will damage the LED Driver.
CAUTION: The weight of the LED Panel is not designed to be
supported by the ceiling grid. The LED Flat Panel must be connected
back to the structure. Failure to do so can cause serious injury.
3
Connecting the electrical wires
□ Unscrew the driver cover by Phillips Screwdriver (not included).
□ Connect the wires from the LED Driver as follows
- Connect L to live wire of junction box, connect N to neutral wire of junction box
□ Connect the yellow wire from the LED Driver to the grounding wire from the junction box.
□
If you use the dimmer, connect DIM- to “-” of dimmer, connect DIM+ to “+”.
L
GND
DIM-
DIM+
LED+
LED
N
20-16AWG
22-12AWG
22-12AWG
0-10V/PWM/RX Dim
LED Driver
ming
GND( )
AC100-277V/50-60Hz
Outlet hole
white
yellow
red
-