Instructions / Assembly

8
PIR Sensor Testing
1
Lighting the product and preheat
□ When power is rst applied, the light will turn on immediately. Waiting for 20 seconds to allow
the sensor to warm up.
2
Test Mode
□ The motion sensor must be tested before setting the
time and sensitivity levels. The TEST option is located on
the TIMER control knob on the underside of the sensor
head. To test the xture, switch the wall switch that
controls power to the xture to the ON position and turn
the rotary knob to the “TEST” area. During test mode.
the lights will come on for 20 seconds, regardless of
motion detection or the time of day. The light will shut
off automatically after 20 seconds. Leave the rotary knob
in the “TEST” area and test the sensitivity by crossing
in the path of the sensor. The light will come on only if it
senses movement. Once movement stops, it will turn off
in 5 seconds. The test is now complete.
3
Sensitivity Set-up
□ The control knob located on the opposite side is Marked SENSITIVITY, which determines the degree of
Motion detection. Rotating this knob clockwise raises the sensitivity of the motion sensor for up to 60 ft.
of distance. Rotating the knob counterclockwise lowers the sensitivity down to as close as 5 ft. It may
be necessary to adjust the “SENSITIVITY” knob several times until the desired setting is achieved. NOTE:
The higher sensitivity level increases the Likelihood of a false activation being triggered.
□ When selecting a location, be aware that the motion sensor is more sensitive to movement across its
coverage area and less sensitive to movement toward or away from the motion sensor (Fig.1).
Fig.1
SENSOR
Least sensitive
SENSOR
Most sensitive