User's Manual
Table Of Contents
- 1 Introduction
- 2 Getting Started
- 3 Configuration
- 3.1 Before you begin
- 3.2 Connecting to your GoBox configuration interface
- 3.3 Managing Operational Profiles
- 3.4 Managing Duplexers
- 4 Using the GoBox
- 4.1 Turning your GoBox On
- 4.2 Selecting an Operational Profile
- 4.3 Stopping Repeater Operation
- 4.4 Checking GoBox Status
- 4.5 Administration
- 5 Troubleshooting
- 5.1 Cannot connect to the GoBox web interface
- 5.2 Network Status icon displays REG ERR
- 5.3 Network Status icons displays PSWD
- 5.4 Network Status icon WWW does not turn solid
- 5.5 Network Status icon VPN does not turn solid
- 5.6 Network Status icon RNC does not turn solid
- 5.7 Status window displays Err:Ctrl
- 5.8 Status window displays Err:Rad1, Err:Rad2 or Err:Rad12
- 5.9 There are no profiles to select on the GoBox control panel
- 5.10 GoBox web interface displays “Template Syntax Error”
- 5.11 The LEDs and the LCD backlight do not turn on
- 5.12 When turning on the GoBox, the LEDs flash rapidly for a second, and the LCD stays blank
- 6 Glossary
SFFR-6 User Manual
Using the GoBox
Doc ID: ES1002-UM02-v508
Copyright © 2021 Etherstack
Page 54 of 63
A progress screen is shown for the duration of the installation process, and is updated approximately once a second. If the
web interface itself is being updated, progress screen updates may be suspended for up to 20 seconds.
During an update, the status display on the GoBox will generally show “Updating” and the power/status and Rx LEDs will
flash. Certain upgrade steps may temporarily turn off the status display and LEDs entirely.
Once the installation process has completed, clicking on Close will return to the firmware overview page.
If the progress page stops refreshing during an update, e.g. because the network connection was interrupted, or the
user navigates away in the browser, the update will nevertheless continue.
Open http://172.16.10.1/update/progress/ to resume viewing the status of the update.
!