User's Manual
Table Of Contents
- 1 Introduction
- 2 Getting Started
- 3 Configuration
- 3.1 Before you begin
- 3.2 Connecting to your GoBox configuration interface
- 3.3 Managing Operational Profiles
- 3.4 Managing Duplexers
- 4 Using the GoBox
- 4.1 Turning your GoBox On
- 4.2 Selecting an Operational Profile
- 4.3 Stopping Repeater Operation
- 4.4 Checking GoBox Status
- 4.5 Administration
- 5 Troubleshooting
- 5.1 Cannot connect to the GoBox web interface
- 5.2 Network Status icon displays REG ERR
- 5.3 Network Status icons displays PSWD
- 5.4 Network Status icon WWW does not turn solid
- 5.5 Network Status icon VPN does not turn solid
- 5.6 Network Status icon RNC does not turn solid
- 5.7 Status window displays Err:Ctrl
- 5.8 Status window displays Err:Rad1, Err:Rad2 or Err:Rad12
- 5.9 There are no profiles to select on the GoBox control panel
- 5.10 GoBox web interface displays “Template Syntax Error”
- 5.11 The LEDs and the LCD backlight do not turn on
- 5.12 When turning on the GoBox, the LEDs flash rapidly for a second, and the LCD stays blank
- 6 Glossary
SFFR-6 User Manual
Using the GoBox
Doc ID: ES1002-UM02-v508
Copyright © 2021 Etherstack
Page 47 of 63
4.5.6 Network Configurations
When an operational profile is using Network mode, it references a number of common settings that are defined by the
Network Configurations Administrative page. This page provides settings including the IP Address, Subnet Mask and
Default Gateway that can be combined into a network configuration. Additionally, VPN settings are included as part of the
network setup to allow a number of similar profiles to re-use the same network details without requiring manual re-entry
of these fields.
To view the Network Configurations, click the Network Configurations menu item on the left hand navigation pane which
will display a list of current network configurations in the content panel.
There is always a Default network configuration which the Standby profile is associated with. This network configuration
cannot be modified or deleted. This allows administrators the ability to always connect to the Standby profile with a direct
Ethernet connection.
To add a new network configuration click the Add Configuration button.