User's Manual
Table Of Contents
- 1 Introduction
- 2 Getting Started
- 3 Configuration
- 3.1 Before you begin
- 3.2 Connecting to your GoBox configuration interface
- 3.3 Managing Operational Profiles
- 3.4 Managing Duplexers
- 4 Using the GoBox
- 4.1 Turning your GoBox On
- 4.2 Selecting an Operational Profile
- 4.3 Stopping Repeater Operation
- 4.4 Checking GoBox Status
- 4.5 Administration
- 5 Troubleshooting
- 5.1 Cannot connect to the GoBox web interface
- 5.2 Network Status icon displays REG ERR
- 5.3 Network Status icons displays PSWD
- 5.4 Network Status icon WWW does not turn solid
- 5.5 Network Status icon VPN does not turn solid
- 5.6 Network Status icon RNC does not turn solid
- 5.7 Status window displays Err:Ctrl
- 5.8 Status window displays Err:Rad1, Err:Rad2 or Err:Rad12
- 5.9 There are no profiles to select on the GoBox control panel
- 5.10 GoBox web interface displays “Template Syntax Error”
- 5.11 The LEDs and the LCD backlight do not turn on
- 5.12 When turning on the GoBox, the LEDs flash rapidly for a second, and the LCD stays blank
- 6 Glossary
SFFR-6 User Manual
Using the GoBox
Doc ID: ES1002-UM02-v508
Copyright © 2021 Etherstack
Page 45 of 63
4.5.5 Settings
4.5.5.1 GoBox Name
The GoBox can be assigned a name to help identify it when accessed via the web interface. The name will appear in the top
right corner of all pages visited on the web interface. The user may adopt any naming convention and uniqueness is not
enforced.
4.5.5.2 Web Access Controls
An administrator (the GoBoxUser account) may restrict actions that can be performed via the web interface by users who
have not logged in (anonymous users). These actions include viewing (or backing up) the GoBox configuration and log files,
adding/editing profiles and settings, selecting the active profile, and updating the GoBox firmware. If the administrator is
accidentally locked out of the web interface, please contact support.
4.5.5.3 Adjusting the LED and LCD Backlight Brightness
To change the brightness of the Rx/Tx and Status LEDs and LCD Backlight, select Settings from the navigation pane.
The brightness can be set in 5 levels, corresponding approximately to off, 3%, 10%, 30% and 100%. Select a brightness level
and click Save.
The brightness will be set to the highest level after a power cycle or factory reset.
Changes made on the Settings page will apply globally to all GoBox operational profiles.
!
Updating and saving the brightness will take several seconds. If the page does not update automatically after a
short time, it may be necessary to click the Refresh button.
!
The brightness of the network traffic LEDs on the control module cannot be changed.
!