User's Manual
Table Of Contents
- 1 Introduction
- 2 Getting Started
- 3 Configuration
- 3.1 Before you begin
- 3.2 Connecting to your GoBox configuration interface
- 3.3 Managing Operational Profiles
- 3.4 Managing Duplexers
- 4 Using the GoBox
- 4.1 Turning your GoBox On
- 4.2 Selecting an Operational Profile
- 4.3 Stopping Repeater Operation
- 4.4 Checking GoBox Status
- 4.5 Administration
- 5 Troubleshooting
- 5.1 Cannot connect to the GoBox web interface
- 5.2 Network Status icon displays REG ERR
- 5.3 Network Status icons displays PSWD
- 5.4 Network Status icon WWW does not turn solid
- 5.5 Network Status icon VPN does not turn solid
- 5.6 Network Status icon RNC does not turn solid
- 5.7 Status window displays Err:Ctrl
- 5.8 Status window displays Err:Rad1, Err:Rad2 or Err:Rad12
- 5.9 There are no profiles to select on the GoBox control panel
- 5.10 GoBox web interface displays “Template Syntax Error”
- 5.11 The LEDs and the LCD backlight do not turn on
- 5.12 When turning on the GoBox, the LEDs flash rapidly for a second, and the LCD stays blank
- 6 Glossary
SFFR-6 User Manual
Using the GoBox
Doc ID: ES1002-UM02-v508
Copyright © 2021 Etherstack
Page 38 of 63
The GoBox will continue to display “Standby” and the power/status LED will blink green, until an operational profile is
selected.
4.3.2 Web Interface
Select Active Profile under the heading Status of the navigation pane, and click on the Stop button.
4.4 Checking GoBox Status
The GoBox displays several indicators in the status window such as power source, battery state and active operational
profile and if a laptop/PC is connected additional status information can be viewed.
4.4.1 Status Window
4.4.1.1 Checking Battery Status
Two rectangles will appear in the top right hand corner of the status window to indicate if any of the batteries are detected
in the battery compartment.
A solid rectangle indicates a battery is inserted and is fully charged. A partially filled rectangle indicates the remaining
battery charge. When a battery has no charge remaining it will be represented as an empty rectangle.
The GoBox has a built in battery charger. When AC or DC power is available, any batteries detected in the GoBox will be
charged. This will be indicated by a scrolling battery charge image.
An external battery charger is also available.
!